ETU ++ is a replacement for the G&G ETU electronic board. It enhances your trigger unit by adding many new, useful features. Simply disconnect the main board and plug in the ETU ++. The original switch set is retained, so there is no need to open the gearbox. Works with any G&G ETU replica, as well as with 7.4 V, 11.1 V, and 14.8 V batteries.
Features:
- Independently programmable shooting modes
- Active brake with adjustable braking power
- Pre-cocking (with spring release function)
- Binary trigger
- Adjustable fire rate
- DMR mode
- Low battery voltage alarm
- Programming supported by multicolor LED
- Diagnostic system
- Electronic resettable safety
Description of functions:
Independently programmed shooting modes - Program shooting modes as you like by setting safety, single shot, burst or auto on all selector positions.
Active Brake - The active brake stops the motor after each shot to prevent spring compression, or in the case of high-speed shooting replicas, overshoot (double shot problem).
Pre-cocking - Quick trigger response can be the difference between victory and defeat, especially in CQB situations. With pre-cocking activated, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot will be fired immediately after the trigger is pulled. To release the spring, press the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without pre-load and fully cocked.
Binary trigger - Allows for easy double shots in semi-automatic setting. After activating this mode, if semi-automatic is set, shots will be fired not only when the trigger is pressed, but also when it is released.
Reduced rate of shooting - Reduce the rate of shooting to save ammunition or to more realistically fire the replica.
DMR Mode - Represents intervals between semi-automatic shots to comply with DMR rules in some fields.
Low battery voltage alarm - Designed for battery Li-Po and Li-Ion. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be freely turned on and off.
Diagnostic System - Constantly monitors the replica and mOSFET itself. In case of any issues, it will immediately alert you to what it might be, making troubleshooting much easier.
Electronic safety - Protects your r
| Category: | Mosfets, electronics |
|---|---|
| Weight: | 0.033 kg |
| EAN: | 8592870101496 |
| The item has been sold out… | |
Be the first who will post an article to this item!