MOSFET V2 with universal wiring - JeffTron

Professionally designed mOSFET intended for airsoft electric guns.
The device increases the cadence of guns and battery life compared to the original wiring in the weapon.
Fully integrated device inside a v.2 gearbox instead of original trigger contacts according to the Tokio Marui standard.

SPECIFICATIONS:
- Built-in mOSFET on SHS switch contacts
- Simple installation inside v.2 gearbox
- Pre-prepared wiring allows for faster and easier installation into the gun, it is long enough for all types of guns. Simply shorten the wires to the required length and power the connectors (included in the package)
- The device has 2 black wires with thin and rigid MPPE insulation with a cross-section of 1.5 mm2 (AWG16) soldered on, 300 mm length to the motor and 700 mm to the battery, and a blue wire with a cross-section of 0.34 mm2 (AWG22) with a length of 1000mm for connection anywhere to the red wire
- Also included in the package is a 1000 mm long red wire with MPPE insulation with a cross-section of 1.5 mm2
- The wiring is intended for the stock, but can also be routed to the handguard under the condition of reversing the black wire to the battery (resoldering on the board)
- The electronics board is coated with varnish that protects against water ingress into the device
- If you want to use your own wires, choose the variant without wiring
- Designed for springs up to m160 (corresponds to a current of 75A for single shots or 25A for burst shooting for a maximum of 30s). For higher loads, choose MOSFET II (placed outside the gearbox)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V)
- Trigger contacts do not burn
- No current is drawn in the idle state
- Due to the operating principle of the AEG guns mechanism, the piston stops in a random position in AUTO mode
For the correct function of this device, the gearbox must have a functional cut-off lever, selector plate, anti-reverse latch, trigger, and trigger stop (secured), as in a standard gearbox.

PACKAGE CONTENTS:
- mOSFET on switch contacts with connected wires
- Trigger shuttle
- Screw, screw washer (for attaching to the gearbox)
- DeanT male connector
- 30A mini blade safety
- 4x faston receptacle
- 6x black sleeve 3.2mm length 20mm
- 3x black sleeve 4.8mm length 20mm
- Installation manual

WARNING: Installation of this device requires a professional who can solder and disassemble an AEG weapon. Never use a transformer welding machine!
Despite all efforts, 100% compatibility of the device with all version 2 gearboxes cannot be guaranteed.
For most commonly available and widespread brands, the MOSFET - V2 can be installed without major modification.