MOSFET V2 to stock - JeffTron

Professionally designed mOSFET intended for airsoft electric guns.
The device increases the cadence of guns and battery life compared to the original wiring in the weapon.
Fully integrated device inside a v.2 gearbox instead of original trigger contacts according to the Tokio Marui standard.
Ready-made wiring adapted for a stock battery with a Deans connector - no soldering required.

SPECIFICATIONS:
- Integrated mOSFET on SHS trigger contacts
- Simple installation inside v.2 gearbox
- Complete wiring allows for quick and easy installation into the gun, it is long enough for all types of guns with a battery in the rear part
- Power wires are 1.5 mm2 in cross-section with MPPE insulation, blue wire is 0.34 mm2 in cross-section with MPPE insulation
- Wire length between the end of the gearbox and the connector is 290mm
- The electronics board is coated with varnish that protects against water ingress into the device
- If you want to use your own wires, choose the variant without wiring
- If you need a different type of wiring, choose the variant with universal wiring
- Designed for springs up to m160 (corresponds to a current of 75A for single shots or 25A for burst shooting for a maximum of 30s). For higher loads, choose MOSFET II (placed outside the gearbox)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V)
- Trigger contacts do not burn
- No current is drawn in the idle state
- Due to the operating principle of the AEG guns mechanism, the piston stops in a random position in AUTO mode
For the correct function of this device, the gearbox must have a functional cut-off lever, selector plate, anti-reverse latch, trigger, and trigger stop (secured), as in a standard gearbox.

PACKAGE CONTENTS:
- mOSFET on the switch contacts with powered wires, DeanT connector, 30A mini blade safety and with faston sleeves on the wires
- Trigger shuttle
- Screw, screw washer (for attaching to the gearbox)
- Installation manual

WARNING: Installation of this device requires a professional who can solder and disassemble an AEG weapon. Never use a transformer welding machine!
Despite all efforts, 100% compatibility of the device with all version 2 gearboxes cannot be guaranteed.
For most commonly available and widespread brands, the MOSFET - V2 can be installed without major modification.