MOSFET V2 - JeffTron

Professionally designed mOSFET without wiring designed for airsoft electric guns.
The device increases the guns cadence and battery life compared to the original wiring in the weapon
Fully integrated device inside a v.2 gearbox instead of original trigger contacts according to the Tokio Marui standard.

SPECIFICATIONS:
- Built-in mOSFET on switching contacts from company SHS
- Simple installation inside v.2 gearbox
- Stand-alone device without cables, cables with a maximum cross-section of 1.5 mm2 can be used for the power circuit and a maximum cross-section of 0.5 mm2 for the signal circuit
- Suitable for service centers, if you are not confident in soldering wires to the board, choose the option with cabling and accessories.
- Designed for springs up to m160 (corresponds to a current of 75A for single shots or 25A for burst shooting for a maximum of 30s). For higher loads, choose MOSFET II (placed outside the gearbox)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V)
- Trigger contacts do not burn
- No current is drawn in the idle state
- Due to the operating principle of the AEG guns mechanism, the piston stops in a random position in AUTO mode
For the correct function of this device, the gearbox must have a functional cut-off lever, selector plate, anti-reverse latch, trigger, and trigger stop (secured), as in a standard gearbox.


PACKAGE CONTENTS: MOSFET on trigger contacts, trigger shuttle, screw, screw washer (for mounting to the gearbox) and installation manual

WARNING: Installation of this device requires a professional who can solder and disassemble an AEG weapon. Never use a transformer welding machine!
Despite all efforts, 100% compatibility of the device with all version 2 gearboxes cannot be guaranteed.
For most commonly available and widespread brands, the MOSFET - V2 can be installed without major modification.