Micro active brake II - JeffTron

Professionally designed mOSFET with active motor braking for electric airsoft guns.
The piston is not partially cocked during semi-firing, spring does not fatigue, internal parts are not stressed, and nozzle mostly locks the chamber.
For high-rate weapons, it solves the problem of multiple shots in shooting mode on semi.
The device increases the cadence of guns and battery life compared to the original wiring in the weapon.

SPECIFICATIONS:

• Very small device dimensions, fits almost anywhere
• Standalone device without cables, for the power circuit you can use cables with a maximum cross-section of 1.5 mm2 and for the signal circuit a maximum cross-section of 0.5 mm2
• Suitable for service centers, if you are not sure about soldering wires to the board, choose the variant with cabling and accessories.
• Intended for springs up to m160 (corresponds to a current of 75A for single shots or 25A for burst shooting for a maximum of 30s)
• Intended for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V)
• After the contacts open, the excess energy of the motor is used to stop it. The braking effect is strongest with a load motor with neodymium magnets.
• 6-wire connection
• Device size 27x10x7mm
• Trigger contacts do not burn out
• No current is drawn in idle state
• Due to the operating principle of the AEG weapon guns mechanism, the piston stops in a random position in AUTO mode
• For the correct function of this device, it is necessary to have a functional cutoff lever, selector plate cam, anti-reverse latch, trigger, and trigger stop (secured) in the gearbox, as in a standard gearbox