Hop-up chamber MAXX MI-SPORT for ICS CXP/CS4/EBB M4/M16 (without LED) - MAXX

The MI Sport CNC Aluminum Hopup Chamber Unit (with BB Catching System) is precision machined to improve accuracy and provide a consistent air seal for ICS CXP/CS4/EBB series (including old models) M4/M16 AEGs. The MI hopup chamber features a precision dial design for fine hopup adjustment, as well as redesigned hopup levers and concave lugs to work best with R-hop and Standard-Hop to ensure the bBs shoots straight and accurately on every single shot. The Hopup Chamber MI unit is designed to accept a standard ICS nozzle or nozzle lengths from 21.00mm to 21.25mm, and is also fully compatible with stock rubbers and thus with most soft and hard rubbers on the market without FPS loss or pellet drop. The MI hopup chamber features a new CNC Delrin Locking C-Clip design that holds the barrel firmly without wobble or twist, and 3 compression springs at the top, bottom, and center of the housing to ensure the hopup unit is precisely centered, straight, and airtight when modified for a basic or any gearbox V2 with an 11.5mm or 12mm inner bore. More than that, the MI Sport unit's Hopup chamber is specially designed with a BB Latching System to prevent the pellets from falling out after the magazine is removed.

A dual UV LED panel and module kit are optional accessories for illuminating the beads in the dark.Operating voltage from 7VDC - 15VDC (2-4 cells LiPo, 6-13 cells NiCad). (Sold separately) Empty tank detection sensor and electronic switch controller are optional accessories to stop shooting motor / HPA when tank is empty. (Sold separately) Test results: FPS can be increased from 10FPS to 30FPS over base performance. Please check FPS!

Contains:

• 1 x CNC Aluminum MI Sport Hopup Chamber (with BB Catching System)
• 2 x Strong Clear Vinyl Cover Set
• 1 x CNC Aluminum Standard Hop Arm
• 1 x CNC Aluminum R-Hop Arm
• 1 x Silicone Rubber Standard Hop
• 1 x Silicone Rubber R-Hop up
• 1 x CNC Aluminum Precision Concave R-Hop length 4.5 mm
• 1 x CNC Aluminum 6 mm Precision Concave R-Hop
• 1 x CNC Brass Threaded Pin
• 1 x CNC Delrin Locking C-Clip
• 1 x CNC Brass Spacer Holder
• 1 x Brass Barrel Spacer Ring
• 3 x Steel Tension spring

Specifications:

• Total Length: 51 mm
• Total Height: 38.5 mm
• Outer Barrel Diameter (for insertion into gearbox): min. 11.5 mm - max. 12 mm
• Outer Barrel Diameter (for insertion into outer barrel): min. 12 mm
• Inner Barrel Diameter (for nozzle insertion): max. 8.3 mm
• Outer Feeder Diameter (to fit magazine): min. 9.25 mm
• Feeder Length (to fit magazine): max. 6.25 mm
• Material: 6061 aluminum